HL-60-LSLM
参数规格:
HL-60-LSLM
玻璃盘螺栓螺帽光学影像筛选机
Optical image screening machine for glass plate bolt and nut
参数规格
Specifications
本机台外观尺寸(长*宽*高):
约1200mm*1200mm*2200mm
机台重量:约750KG
更换规格:约10分钟
检测范围:
长度:10-60mm;直径3-25mm(可以倒立)
可装4支CCD
速度最快可达600支/分钟
电源:交流单项220V 50HZ
功率:约3KW
roduct Size(L x W x H):
About 1200mm*1200mm*2200mm
Machine weight: about 750KG
Replacement specification: about 10 min
examination range:
Length: 10-60mm; diameter 3-25mm (can be inverted)
Can carry 4 CCD
The fastest speed:600 / min
Power: AC single 220V 50HZ
Power: about 3KW
可检测项目
Suitable for
○螺纹直径公差检测;○最大/最小对边公差检测;
○螺纹牙底径检测;○最大/最小对角公差检测;
○螺纹牙中径检测;○内孔与外圆同心度检测;
○牙距检测;○内孔径有无毛刺检测;
○杆部有无螺纹检测;○头部有无电镀检测;
○斜牙检测;○头部表面开裂(侧面开裂需增加专用镜头);
○粗细牙检测;○内孔直径公差;○尖锐度检测;
○有无焊点,及焊点数检测;○头部真圆度测量;
○焊点面积检测;○搓牙有无到位检测;
○螺帽牙内有无铁屑检测;○各部位台阶公差检测;
○梅花形状及有无滚花检测;○头部厚度公差检测;
○有无牙检测;○总长度公差检测;○牙数检测;
○侧面开裂检测;○螺帽烂牙、坏牙检测;
○Thread diameter tolerance detection; ○Maximum/Minimum alignment tolerance detection;○Threaded teeth bottom diameter detection; ○Maximum/minimum diagonal tolerance detection;○Thread middle diameter detection; ○Concentricity detection of inner hole and outer circle;○Distance detection between teeth;○ Detection for burr in internal aperture or not;
○Thread or not of pole part or not;○ Electroplating on head or not;
○Oblique teeth detection; ○Head surface cracking
○Teeth thickness detection; ○Diameter tolerance of inner hole; ○Sharpness detection;
○Detection for solder joint or not and the number;
○Head roundness measurement;○Solder joint area detection;
○Detection for rub teeth in place or not;
○Detection for iron chip in nut teeth or not;
○Step tolerance detection of each part;○Detection of plum blossoms and annular knurl or not; ○Head thickness tolerance detection;
○Teeth detection; ○Total length tolerance detection;○ Teeth number detection;
○Teeth number detection;
○Side cracking detection; ○Detection for broken teeth and bad teeth of nut;